48-inch Silver Bounce Umbrella
- reversible silver and white umbrella
- offers high contrast silver bounce
- offers soft white bounce
- measures 48" across the top open arc
- standard 3/8" diameter umbrella pole
- 60-Day Absolute Satisfaction Guarantee
- 1-Year Factory Warranty
Our silver and white reversible umbrella offers two qualities of light: it can be used as a bright, highly reflective silver bounce umbrella or a soft white bounce umbrella. The silver side provides a high output bounce that increases contrast, while the soft white side provides a softer source that brightens the total scene. The silver and white reversible umbrella material can be easily removed from the poles and flipped over to use either bounce surface.
Our umbrellas mount simply to all Paul C. Buff™ flash units, with or without the use of a reflector, for heightened bounce or bare bulb configuration. The umbrellas are additionally fashioned with long poles to easily adjust the distance between the light source and the umbrella. For travel, the umbrellas collapse traditionally and can be fastened closed when not in use.
|Across the Arc
||48 inches across the top arc (tip to tip)
||38 inches (straight line diameter)
|Umbrella Rod Diameter
Both the U48SW and U48TWB umbrellas have the same dimensions. The umbrellas measure 48 inches across the top arc of the open umbrella, measured from tip to tip. The umbrellas have a 38-inch diameter, measured tip to tip in a straight line across the open umbrella.
Our umbrellas are compatible with all Paul C. Buff™ flash units. The umbrella poles measure less than 8mm in diameter, fitting inside the umbrella mount on any flash unit that accepts poles 3/8-inch in diameter and larger.
flash units and AlienBees™
flash units (B400, B800 and B1600 units), the umbrella pole fits through the umbrella hole on the top of the unit housing and is held in place by tightening the top umbrella screw. On White Lightning™
flash units and retired Zeus™ flash heads, the umbrella pole fits through either of the dual umbrella holes on the top of the unit housing and is held in place by tightening the top umbrella screw.
On the AlienBees™ ABR800
ringflash and retired Zeus™ ZRM1 ringflash head, the umbrella adapter (supplied with each ringflash) must be used. The umbrella pole fits inside the cone and is held in place by tightening the top umbrella screw. When using an umbrella and the ringflash umbrella adapter, the ringflash acts as a traditional flash unit and can not be used in standard ringflash aim-through mode.